KY-024 Linear Magnetic Hall Sensor Module is an analog/digital module with a built-in potentiometer to adjust the sensitivity of the sensor. Analog output (AO) works in the same way as on the KY – 003. Digital output (DO) allows for a pure HIGH/LOW detection and adjusting the sensitivity of that detection with a potentiometer.
In both cases the GND(-) connects to any ground pin (black) on a Raspberry Pi, VCC(+) power supply (red) connects to the 3.3V on RPI and the signal (S or AO/DO) is linked to any GPIO pin (blue).
When using Hall sensor modules have to be mounted in a correct orientation. One side will respond to the N pole of the sensor while the other side will respond to the S pole.
- Operation voltage 3.3 V, 5 V
- Temperature range of -40 °C to 85 °C
- Current input/output max 8/20mA
- Response time: 3uS (very fast)
4 pin connector, pins as follows:
- AO: Analog Output
- G: 0V Ground
- +: 3.3V – 5V Supply
- DO: Digital Output