DIY Buck LM2596 CC-CV Li-Ion Charger-LED Power Supply

0 Orders
In stock


DIY Buck LM2596 CC/CV Li-Ion Charger/LED Power Supply

This is a very flexible and adaptable charging solution at a budget price.  It can charge pretty much any size lithium ion cell to almost any voltage you need using almost whatever current you need.  You can also use it to power and bench test your LEDs.  This is an inexpensive way to charge those 4.30v and 4.35v cells, as well as LiFePo and many other cells that require different termination voltages.  It is also a good way to charge smaller cells since you can almost infinitely adjust the charging current.

Both constant current and constant voltage values can be independently adjusted.

You need a few additional things to make this work:

  1. Have read the instructions.  Because this is fully adjustable, you could potentially overcharge your batteries resulting in venting, fire, or explosion. You should always double check settings before use.  You can also blow your LED if you are not careful.
  2. A multi-meter capable of reading both voltage and DC current.  You will need this to adjust the board and to verify battery charge levels or LED current.
  3. A DC power supply that is at least 2V more than your output voltage.  For most lithium ion cells this means that you need a 7V+ DC source to power the board.  The rated maximum is 35V input.  Old laptop power supplies work great for this board.
  4. A way to hook up your cells / LEDs.  This can be via alligator clips, magnets, holders, or however you see fit.


  • Input Voltage: 5-35V
  • Input Voltage Must Be At Least 2V Above Output Voltage
  • Output Voltage: 1.25-30V (infinitely adjustable)
  • Constant Current Range: 0-3A (infinitely adjustable)
  • Maximum Output Wattage: 15 watts (without external heatsync)
  • Dimensions: 49mm x 23.4mm


There are no reviews yet.

Be the first to review “DIY Buck LM2596 CC-CV Li-Ion Charger-LED Power Supply”

Your email address will not be published. Required fields are marked *